Installer Setting - Use Refrigerant Leakage Sensor - LG PREMTB10U Manual Del Usuario

INSTALLATION INSTRUCTIONS
82
Installer setting – Use Refrigerant leakage Sensor
It is the function to set when the refrigerant leakage sensor is newly installed in the indoor unit or
when the installed refrigerant leakage sensor is removed.
Press the button for 3 seconds
1
to enter the Thermostat installer
setting
If pressed for a shorter time, it
enters into user setup mode.
2 Press the button to select the option
function code as pictured below.
Select Refrigerant leakage Sensor
3
setting by pressing buttons.
(00: not-use , 01:use)
Function Code Refrigerant leakage
Sensor setting
Press button to save.
4
5
Press the button to exit settings mode.
After setup, it automatically exits after 25
seconds if there is no input. If the
Setting/Cancel button is not pressed, the
mode will not change.