Using The Mill; Overload Protection; Care And Maintenance - Russell Hobbs 18995 Instrucciones

9. Put the plug into the power socket.
10. Turn the speed control to the speed you want (1 = low, 2 = high).
11. Turn the speed control back to 0 to turn the motor off.
• Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
• Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
•
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
• To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
When you have finished:
1. Switch the appliance off (0) and unplug it.
2. Turn the jug anti-clockwise, and lift it off the motor unit.
CRUSHED ICE
For best results, full the jug with between 150ml and 500ml of ice cubes.
Put the lid on the blender, then:
Turn the speed control to Y for a second or two, then release it.
1.
2. Check the results, and adjust.

USING THE MILL

1. Turn the mill upside down.
2. Unscrew the collar.
3. Remove the blade unit and seal.
4. Put the goods to be ground into the bowl – dry goods only.
5. Replace the blade unit and seal.
6. Screw the collar back into place.
7. Turn the mill right way up.
8. Lower the mill on to the motor unit, then turn it clockwise, to lock it in place.
Turn the speed control to Y in short bursts till you achieve the size of grind you want.
9.
10. Let the speed control return to 0.
11. Turn the mill anti-clockwise to unlock it, and lift it off the motor unit.
12. Turn the mill upside down.
13. Tap the mill a couple of times to move all the grounds into the bowl.
14. Unscrew the collar.
15. Remove the blade unit and seal.
16. Empty the bowl.

OVERLOAD PROTECTION

This appliance is fitted with a device to protect it in the event it becomes overloaded or
overheats. If the appliance stops without warning for any reason, do the following:
1. Switch off (O) and unplug the appliance.
2. Allow the appliance to cool down for 15 min
3. Once cooled down the protection device will automatically reset and the appliance can be
used normally again.

CARE AND MAINTENANCE

1. Switch the appliance off (0) and unplug it.
2. Wipe the outside of the motor unit with a clean damp cloth.
3. Hand wash the removable parts.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface
finishes. The damage should be cosmetic only, and should not affect the operation of the
appliance.
To remove the blade unit from the jug:
1. Remove the lid.
4