Kohler K-682 Guía De Propietario página 5

Troubleshooting (cont.)
Troubleshooting Table
Symptoms
2. The interface power
indicator pulses but does
not turn on.
3. The interface functions
normally but no water
flows from the
components.
4. Only cold water from the
outlets.
5. Fluctuating or reduced
flow rate. Valve is
functioning properly.
6. Blend temperature drift or
temperature cycling.
Kohler Co.
Probable Cause
E. The valve memory may require
resetting.
F. If none of the above actions
correct the symptom, the valve
or interface requires servicing.
A. Interface cable connections may
be loose or disconnected.
B. If the above recommended
action does not correct the
symptom, the interface or valve
requires servicing.
A. Inlet/outlet fittings may be
blocked.
B. Hot and cold water supplies are
not turned on.
C. The valve memory may require
resetting.
D. System error.
E. If none of the above actions
correct the symptom, the valve
requires servicing.
A. Hot water supply is either not
turned on or not connected to
the valve inlet.
B. Hot water inlet is blocked.
C. If none of the above actions
correct the symptom, the valve
requires servicing.
A. Inlet/outlet fittings may be
blocked.
B. Water outlet pressure is low.
C. Fluctuating flow.
D. If none of the above actions
correct the symptom, the valve
requires servicing.
A. Fluctuating water temperature.
B. Hot water supply temperature
fluctuation.
5
Recommended Action
E. Disconnect and reconnect the
power supply from the valve.
F. Contact your authorized Kohler
service representative.
A. Check all interface cable
connections, connect if needed.
B. Contact your authorized Kohler
service representative.
A. Check the inlets and outlets for
blockage or debris. Clean the inlet
screens. Refer to the "Clean the
Inlet Screens" section in the
Homeowners Guide.
B. Turn on the water supply to the
valve.
C. Disconnect and reconnect the
power supply from the valve.
D. Check the user interface for an
error code. Refer to the User
Interface Homeowners Guide.
E. Contact your authorized Kohler
service representative.
A. Check if the hot water supply is
turned on and connected to the
valve inlet.
B. Check if the hot water inlet screen
for blockage. Clean or replace the
inlet screen.
C. Contact your authorized Kohler
service representative.
A. Check the inlets and outlets for
blockage or debris. Clean the inlet
screens. Refer to the "Clean the
Inlet Screens" section in the
Homeowners Guide.
B. Check that the flow rate is at or
above the minimum rate required.
Refer to the "Specifications" section.
C. Verify that the dynamic inlet
pressures are within specifications.
Refer to the "Specifications" section.
D. Contact your authorized Kohler
service representative.
A. Check the inlet temperature
differentials and verify they are
sufficient. Refer to "Specifications."
B. Check and make adjustments as
needed.
1043183-5-B