Kohler R706534-8L-SHP Guia De Instalacion página 9

6. Position the Threshold
NOTICE: The threshold must sit on a flat surface.
Thoroughly clean the shower base/bath ledge before proceeding.
If needed, file the ends of the threshold to match the corner radius of the shower wall.
Set the threshold assembly on the flat surface of the shower base/bath ledge, as close to the outside
edge as possible.
Align the threshold even distance along the ledge.
Mark the threshold location, then remove the threshold.
Remove the film from the adhesive on the bottom of the centerguide.
Install the threshold on the marks and press firmly on the centerguide to bond the adhesive.
Kohler Co. 9 1380408-2-B