Unpacking - KNOVA KN SS-162 Manual Del Usuario

12. Use caution when cutting off material that is irregular in
cross section that could pinch the blade before the cut is com-
pleted. A piece of molding for example must lay flat on the
table and not be permitted to rock while being cut.
13. Use caution when cl1ting off round material such as
dowel rods, or tubing. they have a tendency to roll while be-
ing cut causing the blade to "bite''.
14. When backing the blade out of the workpiece, the blade
may bind in the kerf (cut).... this is usually caused by saw-
dust clogging up the kerf. If this happens: turn off the scroll
saw.... remove plug from power source outlet... wedge open
the kerf... back, the blade out of the work piece.
15. never leave the scroll saw work area with the power on,
before the machine has come to a complete stop.
16. do not perform layout, assembly, or setup work on the
table while the cutting tool is operating.
UNPACKING AND CHECKING CONTENTS
WARnInG For your own safety, never connect plug to pow-
er source outlet until all assembly Steps are completed, and
you have read and understood the safety and operational
instructions.
lift here
do not lift
saw by this arm
lift here
17. turn was "OFF" and remove plug from power supply out-
let before installing or removing an accessory or attachment.
18. Should any part of this scroll saw be missing, bent or
fail in any way, or any electrical component fail to perform
properly, shut off power switch and remove plug from power
supply outlet, Replace damaged, missing, and/or failed parts
before resuming operation.
19. think Safety. Safety is a combination of operator common
sense and alertness whenever the scroll saw is in operation.
WARnInG: AlWAyS KeeP AleRt. dO nOt AllOW FAMIl-
IARIty (GAIned FROM FReQUent USe OF yOUR SCROll
SAW) tO CAUSe A CAReleSS MIStAKe AlWAyS ReMeM-
beR tHAt A CAReleSS FRACtIOn OF A SeCOnd IS SUF-
FICIent tO InFlICt SeVeRe InjURy.
CAUtIOn: never lift this saw by the arm which holds the
blade or damage will occur to your saw.
TABLE OF LOOSE PARTS
A. SCROll SAW
b. OWneR'S MAnUAl
C. lOOSe PARtS bAG (including)
1. blade guard assembly
2. Pin end plain end blade
3. t wrench
4. dust blower assembly
3