Assembly; Installing Dust Blower System; Installing Blade Guard - KNOVA KN SS-162 Manual Del Usuario

ASSEMBLY

Mounting Scroll Saw to Workbench
1. When mounting the saw to a workbench a solid wood bench
is preferred over a plywood bench where noise and vibration
will be more noticeable.
2. Hardware to mount this saw to a workbench is nOt sup-
plied with the saw. However, we recommend the hardware
used be no smaller than the following.
Quantity Description
4 Hex. Head Screws, 1/4 20 x length Required
4 Flat Washers, 9/32 I.d.
4 lock washer, g/321.d.
8 Hex nuts, 1/4 20
3. A soft foam pad to place between your scroll saw and work-
bench is nOt supplied with the saw. However, we highly
recommend the use of such a pad (24"x1 2"x1/2") to reduce
noise and vibration.
4. If mounting to a workbench, holes should be drilled through
supporting surface of the workbench using dimensions.
Installing dust blower System
1. Connect one end of the PVC Hose to the brass tube and
the other end to the of the bellows Seat.
2. Position and tighten the brass tube with Clamp and Knob.
3. For best result, the brass tube should be adjusted to direct
air bolt at blade and workpiece.
Installing blade Guard
1. locate the blade guard and carefully install it onto the saw
as shown the blade guard to frame by bolt washer and Knob.
nOte: When cutting at angles, the drop foot can be tilted so
it's parallel to the table and rests flat against the workpiece.
to tilt drop foot, loosen screw, tilt toot so it's parallel to table
and securely tighten screw. the drop foot should always be
lowered until it just rests on top of the workpiece.
PVC HOSe
bRASS tUbe
6
GUARd ASSeMbly
KnOb
dROP FOOt