KNOVA KN SS-162 Manual Del Usuario página 9

b. Pin end blade
note: When installing Pin-end blades, the set screws located
on the upper and lower blade Holders should not be over or
under tightened.
the slot must be slightly wider than the thickness of the blade.
After the blade is installed, me blade tension mechanism will
keep the Pin end blade in place.
b 1 Removing the blade
1. to remove the blade, loosen tension on blade by first lifting
up the Quick Release tension lever. (Fig 1)
2. Remove blade from the upper and lower blade Holder. (Fig 2)
Slightly downward pressure against the upper arm may be
helpful when removing blade from the upper blade Holder.
(Fig 3)
ReleASe tenSIOn
lOOSen
(Fig. 1)
(Fig. 3)
QUICK ReleASe ten-
SIOn leVeR
tIGHten
SlIGHt PReSSURe HeRe
PIn ReCeSS
2 Installin0 the blade
1. Install the blade by inserting one end of the blade through
the Access Hole in the table and hook the blade pin in the pin
recess in the lower blade Holder. (Fig 2)
2. Check to see that the pins are properly located in the upper
and lower blade Holders.
3. to tension blade, lower the Quick Release tension lever.
Check tension on blade, if too tight, turn lever counteclock-
wise. (Fig-4)
note: H the blade is over tensioned, the lever is difficult to
be lowered.
PIn ReCeSS
lOOSen
8
(Fig. 2)
QUICK ReleASe
tenSIOn leVeR
tIGHten
(Fig. 4)