Dell PowerEdge R330 Manual Del Propietário página 141

Steps
1 Disconnect the cables from the control panel board.
CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.
2 Hold the top edge of the LCD control panel at the corners and pull upward until the LCD control panel tabs are released.
3 Pull the control panel away from the chassis.
4 Remove the screws securing the LCD control panel board.
5 Lift the LCD control panel board away from the chassis.
Figure 94. Removing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
1 LCD control panel
3 display module cable retention clip
5 tabs on the LCD control panel (6)
2 notches (6)
4 display module cable
Instalación y extracción de los componentes del sistema 141