Kohler K-13808 Guia De Instalacion página 4

Valve
Supply
Secure to
floor.
Base
Hot and
Cold Water
Supplies
1. Install the Foot Control
Secure the Base
Securely tighten the base to the valve with three flathead screws
(provided).
Connect the lavatory or sink supply to the valve. Refer to the
instructions packed with the lavatory or sink supply.
NOTE: Before securing the base to the finished wall, make sure that
sufficient reinforcement has been added to the finished wall.
Using three (3) flathead screws (not provided), secure the base to
the floor.
Connect the Supplies
Apply thread sealant to both the hot and cold water supplies.
Connect the hot and cold water supplies to the valve.
Fit the cover in place over the valve and base.
NOTE: If the foot pedals make contact with the cover, the height of
the foot pedals must be adjusted. Remove the cover from the valve
105344-2-AD
Key
Secure to
floor.
Valve
and
Flathead
Base
Screw
Hex Nut and
Adjustment Screw
4
Plated Screw
Cover
Valve
and
Base
Kohler Co.