Publicidad
Idiomas disponibles
Idiomas disponibles
G B
I n i t i a l s t a r t u p
C a u tio n !
A
T h e eq u ipm ent should not be used if th e cutting
g e a r an d /o r fastenings are loose, d am ag ed or
w orn.
C arry out a visual inspection before each start-
up.
K * 1 T h e c a m e ra sym bol on th e following p a g e refers
to th e illustrations on P ag e 4 - 7 .
A d j u s t in g t h e c u t t i n g h e i g h t
C a u tio n - R is k o f in ju ry!
A djust th e cutting height only with th e m otor
sw itched off and w hen th e m o w e r b lad e has
co m e to a standstill.
■ A lw ays set all th e w heels to th e sa m e cutting
height.
■ Cutting height adjustm ent depends on the
particular model.
C e n tra l a d ju s tm e n t (C J 1)
1.
Press and hold th e central height adjustm ent knob
( C l 1/1).
■
For sho rter grass, press th e central adjustm ent
han dle dow nw ard ( O 1/2)
■
For longer grass, pull th e central adjustm ent
han dle upw ard ( n 1/2)
■
T h e central height adjustm ent level is indicated
1/3)
(Cl
2.
R e le a s e th e knob at th e desired cutting height.
A x le a d ju s tm e n t o r c e n tra l a d ju s tm e n t ( O 2, 3)
1.
To re le a s e th e lever, press to th e side and hold.
2.
Push th e le v e r to th e left or right to select the
desired cutting height.
3.
Let th e le v e r click into position.
4.
C heck th at all w heels a re se t to th e sa m e position.
Q u ic k a d ju s tm e n t o f in d iv id u a l w h e e ls
o r a x le a d ju s tm e n t
4)
(CJ
1.
To re le a s e th e lever, press to th e side and hold.
2.
Push th e leve r to th e left or right to select the
desired cutting height.
3.
Let th e leve r click into position.
4.
C h ec k th a t all w h ee ls a re se t to th e s a m e position.
In d i v id u a l w h e e l a d j u s t m e n t ( a 5)
1.
Loosen th e w heel bolt.
2.
Insert th e w h ee l bolt in th e hole corresponding to
th e desired cutting height.
3.
Tighten th e w heel bolt.
4.
C h ec k th a t all w h ee ls a re se t to th e s a m e position.
C e n t r a l a x le a d j u s t m e n t ( c i 6)
1.
P lace a thum b at each end of th e axle.
2.
P lace th e fingers under th e m o w e r housing.
3.
Using both thum bs, press th e axle out of its present
height setting notch.
4.
Using both thum bs, push th e axle to th e desired
height setting notch, then allow it to eng age.
5.
C h ec k th a t all w h ee ls a re se t to th e s a m e position.
Publicidad
Capítulos
