Tripp-Lite SRCOOL60KCW El Manual Del Propietario página 17

3. Installation
3
Use a screwdriver to loosen the screws of the wiring terminal block and use ring-type terminals to secure terminal 1, terminal 2 and
terminal 5 wires.
230V Installation
Wiring terminal block
4
Re-install the power supply's cover plate and tighten the cable gland.
Dual input
1
Pull up the knob 1 and remove the power supply's cover plate
(Figure 3-14 : Installation of power wires)
Power wires
Press the knob

(Figure 3-15 : Re-install the power supply's cover plate)
2 at the rear of the cabinet top.
(Figure 3-16: Removal of the power supply's cover plate)
17
208V Installation
Wiring terminal block
Rotate the cable

gland clockwise