ENGLISH
Note Trimmer comb must be attached to the groomer in order to use the hair length
selector.
TO THIN AND TAPER THE BEARD/MOUSTACHE
Use the zoom wheel to set the trimmer comb to the desired length setting. The setting
will appear on the length position indicator. If you are trimming for the first time start with
the maximum trimming length setting (9).
Turn the unit on.
Place the flat top of the trimmer comb against the skin (DIAGRAM A)
Slowly slide the trimmer through the hair. Repeat from different directions as necessary.
If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull
off the comb and brush/rinse off (DIAGRAM B)
TO DEFINE THE BEARD/MOUSTACHE LINE
Remove the trimmer comb attachment (DIAGRAM B)
Start with edge of beard/moustache line and gently lower the trimmer blade onto your
skin (DIAGRAM C). Use motions towards edge of beard/moustache line to trim to
desired locations in facial area and away from beard in neck area.
For finer shaping, raise the pop-up trimmer. Shape as desired.
TRIMMING EDGE OF SIDEBURNS
Remove the trimmer comb attachment (DIAGRAM B)
Start with edge of sideburn, and with the trimmer blades resting lightly against your skin,
use motions towards edge of sideburn line to trim to desired locations in facial area.
For finer shaping, raise the pop-up trimmer. Shape as desired.
TRIMMING THE NAPE OF YOUR NECK
Note: You will need a hand mirror for this operation if performing it alone.
Remove the trimmer comb attachment (DIAGRAM B)
Use your fingers to lift the hair at the base of your head up off the neck. Your index finger
should be covering the roots of the hairs you are lifting to prevent accidental removal by
trimmer.
With your other hand, use the trimmer as shown in (DIAGRAM D)
Using your other hand, hold the trimmer to the base of your neck with the cutting unit
facing up, and move the trimmer up the length of the neck until it touches your finger
covering the hair roots at the base of your head. Be sure to move the unit slowly when
performing this operation and to keep the hair roots at the base of your head out of the
way of the trimmer.
REMOVING THE TRIMMER COMB ATTACHMENT AND
CUTTING ASSEMBLY
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to keep it from
turning.
With your other hand, gently pull the trimmer comb attachment off the trimmer.
Remove the cutting assembly by firmly pushing up on the blade with your thumb.
(DIAGRAM E)
3