Kohler K-2600 Guia De Instalacion página 8

Undercounter Installation (cont.)
Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the locations
shown on the previous table.
Use a setting tool and hammer to secure the anchors.
For All Undercounter Installations
WARNING: Risk of personal injury. Metal surfaces are sharp
and can cause severe cuts. Use gloves and handle lavatory
edges carefully.
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
Install the faucet to the countertop according to the faucet
manufacturer's instructions.
Install the drain to the lavatory according to the drain
manufacturer's instructions.
NOTE: When installing the K-7702 drain, use the tapered gasket
supplied with the lavatory instead of the gasket supplied with the
drain.
Apply a continuous bead of quality sealant to the top surface of
the lavatory rim where it will contact the countertop.
NOTE: The screws provided should be used on countertops with a
minimum 1" (2.5 cm) thickness. For thinner countertops, use
appropriate anchors and fasteners (not provided).
For wood, wood composite, and marble countertops, install the
lavatory to the countertop with the clamps and screws provided.
For other countertop materials, refer to the countertop
manufacturer's instructions for recommended fasteners.
CAUTION: Risk of product damage. Overtightening the nuts
may cause irreparable damage to the lavatory.
Position the lavatory squarely under the cutout before tightening
the clamps. Draw the lavatory rim up against the countertop until
it is snug. Do not overtighten.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Allow the sealant to set for 30 minutes before proceeding.
Proceed to the Complete the Installation section.
1018896-2-C 8 Kohler Co.