Electrical Connection - Bosch SHI Instrucciones De Instalación

Ocultar thumbs Ver también para SHI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Strain Relief
(not supplied)
Figure 26
Strain Relief Plate
Figure 27

Electrical Connection

ELECTRICAL CONNECTION
Strain
HAZARD - Working on an energized circuit
Relief
could result in serious injury or death. Only
Plate
qualified electricians
should perform electrical work. Do not
attempt any work on the dishwasher electric
supply circuit until you are certain the circuit
is de-energized.
Improper electrical work can cause fire. Only
qualified electricians should perform electri-
cal work.
Grounding Instructions
The dishwasher must be properly grounded before
operating. This appliance must be connected to a
grounded metal permanent wiring system, or an equipment
grounding conductor must be run with the circuit
conductors and connected to the equipment grounding
terminal or lead on the dishwasher. Make sure that the
dishwasher is connected to a suitable ground in
compliance with all local codes or, in the absence of a
local code, with the NATIONAL ELECTRICAL CODE in the
United States or the CANADIAN ELECTRIC CODE C22.1-
latest edition in Canada as well as any provincial/state or
municipal or local codes that apply.
1) Retrieve the strain relief plate, and install a strain relief
(not supplied) into the opening on the strain relief plate.
NOTE: Orient the strain relief as shown in Figure 26.
2) Pass the electrical supply cable through the strain relief,
as shown in Figure 27. Leave 3 - 4 inches of insulated wire
extending through the strain relief plate.
3) Tighten the strain relief screws.
4) Slide the strain relief plate into the junction box, and
secure it to the junction box with the supplied screw.
(Continued on next page)
WARNING: ELECTRICAL SHOCK
WARNING: FIRE HAZARD -
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

ShwShy66Shx99a

Tabla de contenido