Hammer Safety Warnings; Machine Elements; Intended Use - Würth Master BMH 40-XES Manual Del Usuario

0702 653 X.book Seite 10 Freitag, 9. Juli 2010 9:37 09
GB
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed. In addition, the general
safety instructions in the enclosed
booklet must be followed. Before
using for the first time, ask for a
practical demonstration.
Wear ear protectors with impact drills. Expo-
sure to noise can cause hearing loss.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
Hold power tool by insulated gripping sur-
faces, when performing an operation where
the cutting accessory may contact hidden wir-
ing or its own cord. Cutting accessory contact-
ing a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.

Machine Elements

1 Dust protection cap
2 Locking sleeve
3 Clamping band
4 Operating mode selector switch
5 Vibration damper
6 On/Off switch
7 Lock-on button for On/Off switch
8 Torque selector switch
9 Dial control for impact rate/speed preselection
10 Push-button for depth-stop adjustment
11 Auxiliary handle
12 Knurled nut for auxiliary handle
13 Depth stop
Not all of the accessories illustrated or described are included
as standard delivery.
10

Hammer Safety Warnings

For further notes on safety refer to the enclosed sheet.
BMH 40-XES: The machine is intended for hammer
drilling in concrete, brick and stone as well as for
chiselling.
MH 5-XES: The machine is intended for chiselling in
concrete, brick, stone and asphalt.
The user is responsible for damage caused by usage
other then intended.
Use suitable detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance. Contact
with electric lines can lead to fire and electric
shock. Damaging a gas line can lead to explo-
sion. Penetrating a water line causes property
damage or may cause an electric shock.
When working with the machine, always hold
it firmly with both hands and provide for a
secure stance. The power tool is guided more
secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Keep your workplace clean. Blends of materi-
als are particularly dangerous. Dust from light
alloys can burn or explode.
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over
the power tool.
Never use the machine with a damaged cable.
Do not touch the damaged cable and pull the
mains plug when the cable is damaged while
working. Damaged cables increase the risk of
an electric shock.
Use only original Würth accessories.

Intended Use