General Description - GYS FLASH 6.12 Manual De Instrucciones

Maintenance:
• If the power cable is damaged, it must be replaced by the
manufacturer, its after sales service or an equally qualified person
to prevent danger.
Regulations:
• Machine compliant with European directives.
• The certificate of compliance is available on our website.
• EAC Conformity marking (Eurasian Economic Community)
• Equipment in compliance with British requirements. The British
Declaration of Conformity is available on our website (see home
page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a domestic bin.

GENERAL DESCRIPTION

The GYSFLASH 6.12 is ideal to charge most lead-acid batteries, often used for cars and many other vehicles. These batteries can be
of many types eg: GEL (gel electrolyte), AGM (absorbed glass mat), WET, MF (Maintenance Free), CA (Calcium)...
This charger has been designed to charge 12V batteries (6*2V elements) from 1.2 Ah to 125 Ah, or for floating charge up to 170 Ah.
START UP
1. Connect the charger to the battery using the proper accessory (clamps, lugs, etc...).
2. Plug the charger to the mains (single phase 220-240Vac 50-60Hz).
3. Select the mode by pressing the
4. During the charge, the device indicates the charge's progress. When the indicator
vehicle. Once the indicator
5. The charge can be interrupted at any time by unplugging the mains plug or pressing the
6. After charging, disconnect the charger from the mains, then disconnect the charger's connections from the battery.
CHARGE MODES
• Modes and Options:
CHARGE mode (14.4V/0.8A) :
Mode designed for lead-acid batteries, 12V from 1.2 Ah to 15Ah. 8 step automatic maintenance cycle.
CHARGE mode (14.4V/6A) :
Mode designed for lead-acid batteries, 12V from 15 Ah to 125 Ah and up to 170 Ah for floating charge. 8 step auto-
matic maintenance cycle.
COLD/AGM Option (14.7V) :
Modifies the charging voltage at 14.7V to charge the battery during cold weather (Less than 5°C) or for
some AGM batteries or batteries with caps.
REFRESH Option (15.8V):
Option which add an extra step (step 7) to the charge cycle to restore deeply discharged batteries.
Recommendation: Check the battery's water level and if necessary, perform with a Refresh charge.
GYSFLASH 6.12
button. After roughly 5 seconds, the charge starts automatically.
stays on, the battery is completely charged.
: this option is not recommended for charging sealed batteries.
blinks, the battery is ready to start the
button.
EN
7