BGS technic 950 Manual De Instrucciones página 5

DESCRIPTION
UNIT
BATTERY
BATTERIES
Do not mix old and new batteries with this torque wrench.
•
• Do not mix alkaline with carbon zinc or rechargeable lithium-ion (Li-ion) batteries.
Do not install batteries backwards.
•
Do not throw batteries into fire. Batteries can explode or leak causing personal injury.
•
• Remove batteries when storing the torque wrench for a long period. Batteries should be stored
at room temperature.
FUNCTION SETTINGS
Battery
•
Install and change batteries: Open the end cap then insert two 1.5V AAA batteries (positive end
first) into compartment, tighten the cap.
Switch on/off the power
•
Press the power button
modes trace (trACE) & peak hold (PtoP) to use, when switch is done. The LCD will show one of
the mode and digit 00.0.Pr. LCD will display both torque unit and value.
Set Torque Unit Selection: kg/cm, kg/m, lb-in, lb-ft, N/m
•
Please press the button
Set Torque Value. Press the
•
torque, the value will be memorized after flashing 10 seconds then LCD will show 00.0
automatically.
Peak Hold Operation
•
In this mode, an acoustic and optical signal is output when the previously set torque value is
reached. Press
press or
Track Mode Operation
•
In this mode, the display shows the currently applied torque.
Press &
torque.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
BUZZER
for 3 seconds will turn on the LCD screen and buzzer. There are two
& at the same time and release them to select different torque unit.
or
& at same time then release it to get (PtoP) peak hold set up mode, then
button to set up the torque.
in the same time again to get trace (trACE) mode then use
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
LED
LCD
POWER
button to apply a right value then release it to set up
TRACE & PEAK
MEMORY
or to to set up
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed