KPS -LX30LED Manual De Funcionamiento página 36

the device will enter the peak value measurement mode.
5.3 Maximum/minimum value inquiry mode
• Press and hold "MAX/MIN" key for a short time, "MAX" will appear on top
• In max/min value inquiry mode, press "MAX/MIN" key once, you will switch
LCD interface (as shown in figure 5-1-3).
MAX to MIN or MIN to MAX.
• Press and hold "MAX/MIN" for one second, "MAX/MIN" on top LCD interface
will disappear, and the max/min value inquiry mode will exit.
• In non-zero calibration mode, press and hold "MAX/MIN" key for a short time
to use the max/min value inquiry functions..
5.4 Data hold and zero calibration mode
vice will enter the data hold mode.
• Press and hold "HOLD/ZERO" key for a short time, "HOLD" will appear on
the top left position of the LCD interface (as shown in 5-1-4A), then the de-
interface will disappear, and the meter will exit the data hold mode.
• Press and hold the key again, "HOLD" on the top left position of the LCD
• Cover the opto-sensor with the visor, and press and hold "HOLD/ ZERO" key
later, "ADJ" on LCD interface will disappear, and zero calibration mode will
for one second, "ADJ" will appear on LCD interface (as shown in figure 5-1-
automatically exit and return to auto measurement mode.
4B), then the device will enter the zero calibration mode. Several seconds
KPS-LX30LED • Digital light meter
Figure 5-1-3
Tips
36