Progress Lighting AirPro P2599 Manual De Instrucciones página 11

Attaching the Light Kit
CAUTION - To reduce the risk of electrical shock,
disconnect the electrical supply circuit to the fan
before installing the light kit.
1. Remove and retain the three mounting screws
from the switch housing cover of the light kit fitter
assembly (Figure 13).
2. Connect the wires from the switch housing to
the wires from the light kit fitter by connecting
the molded adaptor plugs together (blue to black,
white to white).
3. Carefully tuck all the wires and splices into the
switch housing.
4. Attach the switch housing cover with light kit
fitter to the switch housing using the three screws
that were previously removed.
5. Install the two LED lamps (provided) into the
light fitter sockets (Figure 14).
6. Pass the fan switch chain through the slot cut-off
in the bowl cap (Figure 15).
7. Position the glass bowl over the threaded nipple
and seat the bowl on bowl cap. Pass the fan pull
chain through the bushing in the outer bowl cap
and install the outer bowl cap on the threaded
nipple. Install and finger tighten the finial (Figure
15).
8. Install the pull chain extension chains and fobs
(Figure 16).
CAUTION - Be sure that the fan switch chain does
not make contact with the light bulbs. If necessary
reposition the light fitter to avoid the fan switch
chain from touching the light bulbs.
Blue White
Black Molded
Adaptor Plugs
White
Figure 13
Figure 14
Shade
(glass)
Outer bowl cap
Finial
Fob
pendant
Figure 15
Figure 16
8.