Progress Lighting AirPro P2599 Manual De Instrucciones página 12

Assembling the Fan
without the Light Kit
1. In order to use the fan without the light kit ,
remove the switch box housing from the top of
light kit fitter assembly by removing the center
hex nut inside the switch box housing, and then
thread the switch box housing off the threaded
nipple on the top of the light kit fitter assembly
(figure 17).
2. Press the plastic plug (provided) into the center
hole of the switch box housing (figure 18).
3. Remove and retain the three mounting screws
from the switch housing cover of the light kit fitter
assembly (Figure 13).
4. Position the switch box housing onto the switch
cup and reinstall the light kit mounting screws
(figure 19).
5. Install the pull chain extension chain and fob
(Figure 20).
9.
Hex nut
Switch box
cover
Figure 17
Switch box
cover
Plug
Figure 18
Switch box
Switch box
cover
Plug
Fob
pendant
Figure 19
Figure 20