Spark Arresting Screen* In Muffler; Checking The Spark Plug - Stihl HL 75 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
Spark Arresting Screen* in
Muffler
If the engine is low on power, check the
spark arresting screen in the muffler.
:
Lift spark arresting screen and pull it
out sideways.
:
Clean spark arresting screen if
necessary.
:
If screen is damaged or coked up, fit
a new one.
:
Refit the spark arresting screen.
*
see "Guide to Using this Manual"
24

Checking the Spark Plug

Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition of
the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
:
Remove spark plug - see "Starting /
Stopping the Engine".
:
Clean dirty spark plug.
:
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
:
Use only resistor type spark plugs
of the approved range.
Rectify problems which have caused
fouling of spark plug:
:
Too much oil in fuel mix.
:
Dirty air filter.
:
Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after approx. 100
operating hours
or earlier if the electrodes are badly
eroded.
HL 75, HL 75 K

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Hl 75 k

Tabla de contenido