Spark Arresting Screen* In Muffler - Stihl FS 110 Manual De Instrucciones

Cutting tool rotates when engine is
idling
:
Turn idle speed screw (LA) slowly
counterclockwise until the tool stops
rotating and then turn the screw
1 3
about another / to /
2 4
same direction.
Erratic idling behavior, engine stops
even though setting of LA screw is
correct, poor acceleration
Idle setting too lean:
: Turn low speed screw (L)
counterclockwise (no further than
stop) until the engine runs and
accelerates smoothly.
Erratic idling behavior
Idle setting too rich:
:
Turn low speed screw (L) clockwise
(no further than stop) until the
engine runs and accelerates
smoothly.
FS 110
Spark Arresting Screen* in
Muffler
: If the engine is low on power, check
the spark arresting screen in the
muffler.
:
Wait for muffler to cool down.
turn in the
: Move slide control to STOP – $.
:
Remove the screw (1).
:
Remove the screws (2).
:
Lift away the shroud (3).
* see "Guide to Using this Manual"
1
3
2
2
English / USA
: Remove the screw (4).
: Lift spark arresting screen (5) and
pull it out.
:
Clean spark arresting screen if
necessary – if screen is damaged or
coked up, fit a new one.
:
Refit the spark arresting screen.
:
Insert screw and tighten down.
: Fit the shroud.
39