Defrosting The Appliance; Prolonged Periods Of Disuse; Cleaning The Appliance; Troubleshooting - Nevir NVR-5203 CVSD Instrucciones De Operación

you can cook small items directly from frozen by lengthening the cooking time slightly, or put the big size
items in a microwave oven to reduce the defrosting time.

Defrosting the appliance

Frost on the inner cooling walls of the refrigerator is eliminated automatically every time the motor
compressor is shut down. Water from melted frost is collected by means of a channel which leads to a water
tray installed above the motor compressor at the rear of the unit. Heat generated by the motor compressor
ensures evaporation of the water. Periodically clean the defrost water drain outlet in the refrigerator
compartment.
Defrost the freezer compartment when the ice/frost is approximately 3-4mm thick. Set the thermostat dial to
"OFF" or "0" to defrost. Remove all contents from the freezer compartment. Leave the freezer door open to
allow accumulated ice/frost to melt. Remove large pieces of ice as need. Do not use hot water or other electric
heating devices to melt the accumulated ice. After defrosting, remove accumulated ice/water and wipe the
freezer compartment with a soft cloth. Restart the unit per starting instructions.
Never use a knife or other sharp metal instrument to scrape ice/frost from the inside of the unit.

Prolonged periods of disuse

If you do not intend to use the appliance for long periods of time. Set the thermostat knob to the "OFF"
position and disconnect the power supply. Then take out the foods, defrost and clean the appliance. Leave the
door slightly open.

Cleaning the Appliance

Disconnect the power supply before cleaning the appliance.
Do not use coarse or aggressive cleaning agents as you may damage the surface.
Clean the exterior with cloth.
Remove the detachable accessories in the interior of the appliance and clean with water and liquid detergent.
Plastic parts cannot be washed in dishwashers.
Wash the interior of the appliance with wet cloth, adding one or two spoonfuls of vinegar.
After cleaning, connect the appliance to power supply and reload it.

TROUBLESHOOTING

Defective operation of the appliance is not always due to a technical fault but is often caused by incorrect
installation or use. To avoid unnecessary technical assistance and relative expenses we recommend the
following procedures.
1. Internal temperature is not cool enough
Check:
- make sure that the door closes properly;
- make sure that the thermostat setting is correct;
- make sure that the refrigerator is not positioned close to heat sources;
- make sure that air can circulate freely at the rear of the appliance;
- make sure that the condenser is not blocked.
2. Internal temperature is too low
Check:
-make sure that the thermostat setting is correct.
3. Excessive appliance noise level
7