Metra AX-ADMZ01 Instrucciones De Instalación página 2

WIrInG tHe aX-admZ01
Only make the following connections if the vehicle is non-amplified.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the purple wire to the radio's right rear positive speaker output.
• Connect the purple/Black wire to the radio's right rear negative speaker output.
• Connect the Green/purple wire to the reverse wire of the aftermarket navigation radio.
InstallInG tHe aX-admZ01
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30-seconds. Then off and on again to
test the radio.
testInG tHe aX-admZ01
1. Turn the radio on and check balance and fader controls for proper operation.
2. Start the vehicle and check all A/C operations.
setting the oe clock using the service harness
1. Make sure the vehicle is in the off position.
2. Plug in the OEM radio and turn on the ignition.
3. Set the time.
4. Shut off the vehicle and unplug the factory radio.
5. Tuck the service harness back in the dash.
asWc-1 (if installing)
After the interface is initialized, plug in the ASWC-1 into the 12-pin harness of the AX-ADMZ01
and refer to the ASWC-1 instructions.
AX-ADMZ01
(continued)
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians