Connections - Metra AXXESS NITO-01 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an accessory wire on the NITO-
01 harness to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Tape off and disregard the following (13) wires, they will not be used in this application:
Blue/Pink, Blue/White, Brown, Gray, Gray/Black, Green, Green/Black, Green/Purple,
Purple, Purple/Black, Light Green, White, White/Black
From the NITO-01 harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• If installing an ASWC-1 (sold separately), connect the Red wire to the accessory wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
2

CONNECTIONS

The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
Note: Before connecting this wire, also refer to the "AX-CAM6V 12-volt to 6-volt" converter section .
• Connect the Light Green wire to the parking brake wire.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera
input. Please reference "Reverse camera operation" on page 4 if retaining the camera.
12-pin ASWC-1 harness & 3.5mm jack:
• This 12-pin ASWC-1 harness & 3.5mm jack are to be used with an ASWC-1 (sold separately)
to retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this
harness and 3.5mm jack. If it is to be used, please refer to the ASWC-1 instructions for radio
connections and programming. Disregard the harness that comes with the ASWC-1.
AX-CAM6V 12-volt to 6-volt converter:
• Connect the Black wire to chassis ground.
• Connect the Blue/Red wire to the Red wire labeled "Camera Power 6V".
• Connect the Blue/White wire to the Green/Purple wire.
Note: The Green/Purple wire will connect to both the AX-CAM6V, and the aftermarket radio.