Connections - Metra 95-6553B Instrucciones De Instalación

For models without a factory amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• Connect the Gray wire to the right rear positive speaker output.
• Connect the Gray/Black wire to the right rear negative speaker output.
• Connect the White wire to the left rear positive speaker output.
• Connect the White/Black wire to the left rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following wires, they will not be used in this application:
Blue/White, Green, Green/Black, Purple, Purple/Black, Brown

CONNECTIONS

From the car side harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Purple wire to the right front positive speaker output.
• Connect the Purple/Black wire to the right front negative speaker output.
• Connect the Green wire to the left front positive speaker output.
• Connect the Green/Black wire to the left front negative speaker output.
• Ensure the (2) 4-pin Molex connectors are connected together.
• If the AUX-IN jack in the dash is desired to be used, connect the Red and White RCA jacks to
the audio AUX-IN jacks of the aftermarket radio.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse
camera input.
Continued on the next page
5
REV. 8/12/2021 INST95-6553B