User Interface - Cebora 436.00 Manual De Instrucciones

6

USER INTERFACE

Once the power source has been installed, the kit is recognised automatically. An example of the user
interface is given below. (WIN TIG).
On the Home screen, select "Accessories"
Go back to the Home screen and select "Process Parameter"
The Gas Flow parameter is the set-point flow to be implemented by the regulator. The regulator is set to
Argon gas as standard. This means that setting a Gas Flow of 1 l/min gives an Argon gas output of 1
l/min.
If using gas other than Argon, enter a correction factor (as shown in the table in Chapter 7) and obtain the
gas flow parameter setting using the following equation:
GasFlow

GasFlow
Correction
GasFlow_new = new gas set-point value
Correction_coefficient = correction value for the new gas in the table given in section 7
Example: If the new gas is CO2 and the required setting is 2 l/min then:
2
 
GasFlow 3 5 ,
l/min value to be set on the display if required CO2 flow is 2 l/min.
, 0 57
3301121
Use the encoder to set the flow rate "l/min"
_ new
_ coefficien t
Set "Gas Regulation Kit"= ON
Select "Gas Flow"
EN
15