Powering On/Off - Soundcore Spirit Dot 2 Manual Del Usuario

Charging
• Slide to open or close the charging case to activate the LED battery indicator.
• Fully charge both the earbuds and the charging case before the first use.
• To prevent damage, use the provided USB-C cable.
• Fully dry off the earbuds and the USB port before charging.
< 30%
30% - 70%
> 70%
100%
LED behavior (Earbuds)
Flashing red once every 1 minute
Steady white
Light off

Powering On/Off

The earbuds will automatically power on when taken out of the charging case and power off
when placed back into the charging case.
ON
OFF
01 EN
Low battery
Being charged
Fully charged
• To manually power on, press and hold the multi-function button on both earbuds for 2
seconds until the LED indicators turn white for 1 second.
• To manually power off, press and hold the multi-function button on both earbuds for 8
seconds until the LED indicators turn red for 1 second.
Pairing
True Wireless Stereo Connection
The right earbud will automatically connect with the left earbud when taken out of the
charging case.
LED behavior (Earbuds)
Flashing white
Rapidly flashing white (Primary earbud)
Slowly flashing white (Secondary earbud)
• The right earbud is the primary earbud by default. In TWS mode, place either one of the
earbuds into the charging case, the other one will switch to be the primary earbud.
• When powered on and connected, if either one of the earbuds is out of battery and
powered off, you can keep using the other one.
Bluetooth Pairing with your Device
1. Take earbuds out of the charging case or manually power on the earbuds, wait for 1 to 3
seconds until the LED indicator on one of the earbuds flashes white, then earbuds enter
the Bluetooth pairing mode successfully.
2. Turn on Bluetooth on your device and click "Soundcore Spirit Dot 2" . The LED indicators
on both earbuds will turn white for 1 second when Bluetooth connected.
TWS connecting
TWS connected
EN 02