Powering The Laser - DeWalt DW089LR Manual Del Usuario

• Remove dead batteries immediately and dispose of
per local codes.
• Do not dispose of batteries in fi re.
• Keep batteries out of reach of children.
• Remove batteries when the device is not in use.
• Use only the charger specifi ed for your rechargeable
battery pack.
• Disconnect the battery pack from the laser before
making any adjustments, changing accessories, or
storing the laser. Such preventative safety measures
reduce the risk of starting the laser accidentally.
• When the battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws, or other small metal objects that
can make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fi re.
• Use the laser only with specifi cally designated
battery packs. Use of other battery packs may create
a risk of injury and fi re.
• Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, fl ush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
• Do not use a battery pack or laser that is damaged or
modifi ed. Damaged or modifi ed batteries may exhibit
unpredictable behavior resulting in fi re, explosion, or
risk of injury.
• Do not expose a battery pack or laser to fi re
or excessive temperature. Exposure to fi re or
temperature above 265° F (130° C) may cause an
explosion.
• Follow all the charging instructions and do not charge
the battery pack outside of the temperature range
specifi ed in the instructions. Charging improperly or
at temperatures outside of the specifi ed range may
damage the battery and increase the risk of fi re.

Powering the Laser

This laser can be powered by either of these battery
packs:
• A DEWALT 12V MAX* Li-ion Battery Pack
(DCB120, DCB122, DCB123, DCB125, or DCB127).
*Maximum initial battery voltage (measured without a
workload) is 12 volts. Nominal voltage is 10.8.
• A DEWALT AA Starter Pack with 4 new high-quality
name brand AA batteries. Note: The AA Starter Pack
is only recommended for use with the red laser
(DW089LR or DW0811LR).
Use of any other batteries may create a risk of fi re.
Charging the Li-ion Battery
If the DEWALT 12V MAX* Li-ion battery pack is
1.
attached to the laser, remove it.
• Rotate the laser so it is easier to access the
battery pack (Figure ).
C 1
• While pressing down on the release button on the
battery pack (Figure ), pull the battery pack
C 2
up to unlock it from the laser.
• Pull the battery pack the rest of the way up and
out of the laser (Figure ).
C 3
Plug the charger cord into an electrical outlet.
2.
Slide the battery pack into the charger until it snaps
3.
in place (Figure ). On the charger, the left
B 1
indicator light will flash to let you know the battery is
being charged.
After the battery is fully-charged (the indicator light
4.
on the charger no longer flashes), press and hold
the release button on the battery pack (Figure
) and slide the pack out of the charger
B 2
(Figure ).
B 3
Slide the battery pack down in the laser until it
5.
snaps in place (Figure ).
B 4
E
13