DeWalt DW089LR Manual Del Usuario página 16

Horizontal Beam - Pitch Direction
E
Checking the horizontal pitch calibration of the
laser requires a single wall at least 30' (9m) long.
It is important to conduct a calibration check using
a distance no shorter than the distance of the
applications for which the tool will be used.
Place the laser against the end of the wall on a
1.
smooth, fl at, stable surface that is level in both
directions (Figure ).
L 1
Move the Power/Transport Lock switch to the right
2.
to turn the laser ON.
Press to turn on the horizontal beam.
3.
At least 30' (9m) apart along the laser beam, mark
4.
and .
a
b
Move the laser to the opposite end of the wall
5.
(Figure ).
L 2
Position the laser toward the fi rst end of the same
6.
wall and parallel to the adjacent wall.
Adjust the height of the laser so the center of the
7.
beam is aligned with .
b
Directly above or below , mark
8.
a
beam (Figure ).
L 3
Measure the distance between
9.
If your measurement is greater than the Allowable
10.
Distance Between and
c
a
ing Distance Between Walls in the following table,
the laser must be serviced at an authorized service
center.
Distance Allowable Distance
Between Walls Between
30' (9m) 1/4" (6.0mm)
40' (12m) 5/16" (8.0mm)
50' (15m) 13/32" (10.0mm)
16
Vertical Beam (DW089)
Checking the vertical (plumb) calibration of the
laser can be most accurately done when there is a
substantial amount of vertical height available, ideally
30' (9m), with one person on the fl oor positioning
the laser and another person near a ceiling to mark
the position of the beam. It is important to conduct a
calibration check using a distance no shorter than the
distance of the applications for which the tool will be
used.
Place the laser on a smooth, fl at, stable surface
1.
that is level in both directions (Figure
Move the Power/Transport Lock switch to the right
2.
to turn the laser ON.
Press and
3.
Mark two short lines where the beams cross
4.
, and also on the ceiling
a b
the center of the beam's thickness (Figure
Pick up and rotate the laser 180º, and position it
5.
so the beams line up with the marked lines on the
level surface (
along the laser
Mark two short lines where the beams cross on the
c 6.
ceiling ,
g
h
and .
Measure the distance between each set of marked
a c 7.
lines on the ceiling (
surement is greater than the values shown below,
for the correspond-
the laser must be serviced at an authorized service
center.
Ceiling Height
8' (2.5m)
and
a c
10' (3m)
14' (4m)
20' (6m)
30' (9m)
).
M 1
to turn on both vertical beams.
, . Always mark
c d
).
M 2
, ) (Figure ).
e
f M 3
.
, and , ). If the mea-
g
c d h
Allowable Distance
Between Marks
1/16" (1.5mm)
3/32" (2.0mm)
1/8" (2.5mm)
5/32' (4mm)
1/4' (6mm)