Maintenance/Repairs - Uline ECONODOT H-2930 Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

OPERATION AND LOADING INSTRUCTIONS CONTINUED

TO LOAD THE ECONODOT CONTINUED

Press down on the spring-loaded lever located

to the right of the motor-driven and clamp rollers

in order to create space between the two rollers.

Thread the liner between the two rollers. Release the

spring loaded lever so the motor-driven and clamp

rollers sandwich the liner. Close the door on the

shroud. (Shroud door must be closed to operate the

machine.)

8. Pull on the liner until a single adhesive pattern

comes to rest on the nose plate.

9. Spent liner should trail into a trash receptacle.

All maintenance and repairs should be performed

by a technical staff member such as a technician,

electrician, maintenance personnel or equivalent.

Maintenance performed by unqualified persons

nullifies the EconoDot warranty.

The following chart outlines problems that could arise

while using the EconoDot. Malfunctions experienced

outside of the issues outlined below will need to be

addressed by an experienced, professional technician

or electrician.

OPERATING ISSUE

Motor doesn't turn

Liner advances more than

one adhesive pattern at a

time

When the liner advances,

the adhesive pattern is not

centered on the nose plate

PAGE 3 OF 9