Technical Specifications - ResMed AirMini Guia Del Usuario

• Do not attempt to modify the converter. There are no user-servicable
parts in the converter.
• Do not plug the power cord into a USB port.
• Make sure the power cord and plug are in good condition and the
equipment is not damaged.
• Portable and mobile RF communications equipment should be used
no closer to any part of the machine, including cables, than the
recommended 10 cm separation distance.
• The machine should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, the machine
should be observed to verify normal operation in the configuration
in which it will be used.
CAUTIONS
The Converter is intended for use on 12V or 24V negative ground
systems (where the negative terminal of the battery is grounded).
Using it on a 12V or 24V positive ground system may damage the
converter and the vehicle's electrical system. If you are unsure
whether you have a negative ground system, consult the car, boat or
other vehicle manual.
• Replace fuse with same type and ratings to avoid risk of fire.
• Make sure the converter is not covered during use to avoid
overheating the converter.
• The AirMini DC/DC Converter is not intended for use on an aircraft.
Note: For any serious incidents that occur in relation to this product,
these should be reported to ResMed and the competent authority in your
country.

Technical specifications

Length
(connector to connector)
Fuse rating
Fuse type
Input
Output
Operating temperature
Operating humidity
9.8 ft (3 m)
12A/250V
Slow blow, high breaking capacity
12V/24V 8/4A
24V 2.71A
+41°F to +95°F (+5°C to +35°C)
10 to 95% RH non-condensing
3