Publicidad
Idiomas disponibles
Idiomas disponibles
17. Install ground
Choose the appropriate cable type (Choice 1-3) and follow the
directions given.
If Drain Wire or UniShield Cable
Pigtail the shield wires on each side. Crimp the ground braid onto
one pigtail with the connector provided.
Lay braid across splice tubes and attach to pigtail on the other side.
Cut off excess braid and trim pig-tailed wires.
Discard spring clamps and foil tape.
Go to Step 18.
If Metallic Tape Shield Cable
(1) Flare one end of the ground braid and place it onto the metallic
tape butted up to the installed splice tubes. (2) Attach the braid to
the shield by placing two wraps of the spring clamp over the braid.
(3) Fold the braid back over the spring clamp wraps. Continue to
wrap the remaining clamp over the braid. Tighten clamp by twisting
it in the direction it is wrapped and secure with copper foil tape
provided.
(4) Lay the braid across the splice tube and onto the exposed tape
shield on the other side. (5) Make two wraps of the clamp over the
braid. (6) Fold the braid back toward the splice and finish wrapping
the clamp. Tighten and secure. Cut off excess braid.
Discard connectors.
Go to Step 18.
If Lead Sheath Cable
Solder ground braid(s) or bonding wire on to lead sheath. Deburr
connection. Discard spring clamps, connectors, and foil tape.
Go to Step 18.
PII 53106
Revision AL
Choice 1
Choice 2
Choice 3
Drain Wire Connector
Black/Red Triple Layer Tube
*
UniShield is a trademark of General Cable Technologies Corporation.
GroundBraid SpringClamp
Black/Red Triple Layer Tube
Tubo Nergro/Rojo de Triple Capa
1
Black/Red Triple Layer Tube
Tubo Nergro/Rojo de Triple Capa
Black/Red Triple Layer Tube
Tubo Nergro/Rojo de Triple Capa
6
Ground Braid
2
3
4
5
PCN 690615-000
Effective Date: June 17, 2010
120
122
6
123
121
Publicidad
