Installation Instructions - Cree C-LITE C-DL6 Serie Instrucciones De Instalación

Reconversión led de luz focal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS

C-DL6 Series
LED Retrofit Down Light
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
Male Connector
Female Connector
Embedded On Back
Of Downlight
Male Connector
Female Connector
Embedded On Back
Of Downlight
http://lighting.cree.com/warranty
Document:
LPN000244_B
Created By:
TMT
FIGURE 6
LED HOUSINGS
1.
Plug the female connector of the retrofit trim onto the male
connector of the housing. See Figure 5.
2.
If using torsion springs, squeeze both torsion spring arms together
and insert into the torsion spring slots (or c-clips) of the can. Tuck
all wires into the can and carefully push the retrofit trim into can.
See Figure 6.
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved could void your
authority to use this equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
In accordance with California Proposition 65, Cree provides the
following statement due to the customary electronics
components used in this product. WARNING: This product
contains a chemical known to the state of California to cause
cancer. WARNING: This product contains a chemical known to the
state of California to cause birth defects
or other reproductive harm.
|
866.924.3645
Date
2017-11-26

Publicidad

Tabla de contenido
loading

Tabla de contenido