I
S
U
– ISO-DIN M
NSTALLING THE
OURCE
NIT
OUNT
• Remove Trim Piece and Installation Sleeve from source unit.
• Factory Bracket should align with two mounting holes on each side of
source unit.
• ISO Screws should be 6mm max (use supplied screws).
• Connect Antenna to antenna jack on rear of source unit.
• Install Source Unit into instrument panel.
U
S
U
– S
M
NINSTALLING THE
OURCE
NIT
TANDARD
OUNT
• Disconnect Back strap from rear of radio (if used).
• Insert Release Keys into left and right sides of source unit to disengage locks.
• Remove Source Unit from installation sleeve with release keys.
– 14 –