Ryobi CDI-1443 Manual De Utilización página 13

GB
F D
SPECIFICATIONS
Model
Voltage
Chuck (mm)
Switch
No load speed (drill mode):
- Lo speed (min- 1 )
- Hi speed (min- 1 )
- Super-Hi speed (min-
No load speed (impact mode):
- Lo speed (min- 1 )
1
- Hi speed (min- )
- Super-Hi speed (min-
Max. Torque (Nm)
Weight - incl. battery pack (kg)
Battery pack:
Charger
DESCRIPTION
See Figure 1-9
1. Keyless chuck
2. Switch trigger
3. Direction of rotation selector (Forward/Reverse)
4. Screwdriver bits
5. Battery pack
6. Depth gauge Rod
7. Auxiliary handle
8. Latches
9. Depress latches to release battery pack
10. To Tighten
11. To Loosen
12. Drill bit
13. Drilling Depth
14. To Decrease torque
15. To Increase torque
16. Torque adjusting Ring
17. Drill mode
18. Impact mode
19. Reverse
20. Forward
21. Chuck jaws
22. Unlock (release)
23. Lock (tighten)
24. Battery Charger
25. Green Light
26. Red Light
E I P NL
1
)
1
)
S DK N
English
CDI-1443
14.4 V
13
Variable speed
0 - 350
0 - 700
0 - 2000
0 - 5600
0 - 11200
0 - 32000
50
2.8
BPP-1417/
BPP-1420
BC-1440/
BC-1415-S
OPERATION
LED FUNCTION OF CHARGER
See Figure 9.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
Red LED on = Fast charging mode.
■
Green LED on = Fully charged battery pack.
■
No LED on = Defective charge or battery pack.
■
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles for them to
fully charge.
TO CHARGE
Charge battery pack only with the charger provided.
■
Make sure power supply is normal house voltage,
■
230 volts, 50 Hz, AC only.
Connect charger to power supply.
■
Place battery pack in charger. Align raised rib on
■
battery pack with groove in charger.
9
FIN GR H CZ
CDI-1803
18 V
13
Variable speed
0 - 370
0 - 750
0 - 2200
0 - 5920
0 - 12000
0 - 35200
55
3
BPP-1817/
BPP-1820
BC-1800/
BC-1815-S
RUS RO PL