Cleaning; Troubleshooting; The Sub Compact - Krups THE SUB COMPACT Manual Del Usuario

For the other glasses, hold the tap handle in forward position until the glass is filled .
IMPORTANT: If you pull the handle too slowly you will generate extra foam .
You can consult all the information about serving the perfect beer at www .the-sub .com .
CLEANING AFTER DAILY USE
Clean the drip tray after each use .
!
Note: The drip tray (I) can be washed with hot water and a mild detergent (17) and must
not be washed in the dishwasher .
!
Warning! Never use harsh detergents, such as vinegar, acids, solvents or petrol .
CLEANING DURING INSTALLATION OF A NEW TORP
Clean away all traces of beer that have built up on the tap .
The tap mechanism should be cleaned with a damp cloth and some mild detergent (18) .
Remove the empty TORP from the refrigeration chamber by pressing on the front part to
remove the rear part (19) .
!
Warning! Do not attempt to clean the mechanism with hard and/or sharp objects .
Clean the cooling chamber of THE SUB COMPACT using a soft dry cloth (20) .
Problem
THE SUB
COMPACTT does
not turn on .
The upper part
of the dispensing
head does not fit
correctly .
You can not close
the door of THE
SUB COMPACT .
20

3 - CLEANING

4 - TROUBLESHOOTING

Possible causes
THE SUB COMPACT is not
connected to the mains power
supply .
The electronic board may be
defective .
The upper part of the head is
not correctly inserted .
THE TORP is not inserted
completely .
Remedies
Connect THE SUB COMPACT to
the power supply .
Contact the KRUPS customer
service .
Remove the tube spout from
THE SUB COMPACT and
fit it again following chapter
«Installing THE TORP in THE SUB
COMPACT»
Insert THE TORP in THE SUB
COMPACT completely .