Application Area; Safety Information; Symbols Used - Renfert Vario E Instrucciones De Uso Originales

1 Introduction
We are pleased with your decision to purchase a Vario E wax heating unit.
Please observe the following information in order to ensure long and trouble-free service.
2

Application Area

The Vario E wax warmer heats wax in three independently adjustable pots.
2.1 For modelling waxes
Depending on the adjusted temperature, small or large wax portions can be taken up out of the pots eit-
her directly with the electric modelling instrument or after the instrument has been heated over the flame.
This prevents strong contractions since the waxes are not subject to strong temperature fluctuations. This
ensures that a uniform quality is maintained.
Technicians can therefore model efficiently and rationally with a uniform wax consistency.
2.2 For dipping waxes
It is also possible to use the Vario E as a wax dipping pot. Thanks to its 14.5 mm (0.57 inch) deep wells,
the unit offers ideal conditions.
2.3 For light-curing waxes
With a temperature interval of 45 - 110 °C (113 - 230 °F) the Vario E is particularly suitable for processing
light-curing waxes.
2.4 Ambient Conditions
(in accordance with IEC 60664-1)
The Vario E may only be operated:
• Indoors;
• Up to an altitude of 2,000 m (6,500 ft) above sea level;
• At an ambient temperature of 5 – 40 °C (41 – 104 °F);
• At a maximum relative humidity of 80 % at 31°C (87.8 °F), decreasing linearly to 50 % relative humidity
at 40 °C (104 °F);
• At mains power fluctuations where the voltage fluctuations do not exceed 10 % of the nominal value;
• At pollution degree 2;
• Over voltage category II.
3

Safety Information

3.1

Symbols Used

The following symbols are employed in these instructions and on the unit:
Danger
An imminent danger of injury exists.
Electrical Power
Danger of electrical shock
Attention
Failure to observe this information can result in damage to the unit.
Note
This is a note intended to provide the operator with useful information to make operation easier.
For indoor use only.
Before opening the unit, disconnect it from the power supply by pulling the wall plug.
- 1 -
EN