4. Switch the Vario E on at switch (A) (Figure 4).
5. The most recently selected unit of temperature (°C or °F) appears for approx. 2 sec. on the display (F).
C = degrees Celsius (Figure 7a) or
F= degrees Fahrenheit (Figure 7b)
6. The display (F) then shows the most recently entered setpoint temperature for the selected pot for
approx. 2 sec. The selected pot is indicated by the LED (C).
7. Finally, the display (F) shows the current actual temperature in the most recently selected pot.
The selected pot is indicated by the LED (C).
5.2
Specifying the Desired Temperature Unit (°C or °F)
Note:
Please note that 230 V units have been preset to °C at the factor, while 120 V units are preset to °F.
1. If your Vario E is switched on, please turn it off at switch (A).
2. Press and hold key (B) approx. 2 sec. (Figure 5) while simultaneously turning the Vario E on at
switch (A) (Figure 4).
3. The units of temperature, °C and °F are alternately shown for approx. 2 sec. on the display (F)
(Figure 7a + 7b). Release key (B) when the desired unit is displayed.
4. The most recently displayed unit of temperature is saved.
5.3
Set-point Temperature Adjustment
1. Use switch (B) to select the desired wax pot (Figure 5).
2. The LED (C) associated with the selected pot goes on (red or green) (Figure 6).
- Right-hand wax pot = Right-hand LED;
- Centre wax pot = Centre LED;
- Left-hand wax pot = Left-hand LED;
3. Display (F) first shows the setpoint temperature for approx. 2 sec., followed by the actual temperature.
4. Pressing either key (D +) or (E -) the display (F) switches on to the currently specified setpoint
temperature (Figure 9 + 10).
5. Pressing keys (D +) or (E -) resets the desired setpoint temperature (adjustment range: 45 - 110 °C
or 113 - 230 °F).
= Increase temperature
= Decrease temperature
By pressing the Minus-Key once again at 45 °C (113 °F), the corresponding pot will be switched off
(the display shows OFF). By pressing the plus-key, the pot will be switched on again beginning at
45 °C (113 °F). If an attempt is made to set a temperature higher than 110 °C (230 °F), the value of
110 (230) will flash on the display (F).
6. After approx. 2 sec., the display (F) automatically switches to the actual temperature in the selected
pot.When the pre-set temperature on the selected pot is reached, the indication on the
corresponding LED will turn from red to green (Figura 8). The indication on the LED (C) will always
shortly turn on red when re-adjusting temperature.
Note:
The setpoint temperatures in the individual pots, together with the most recently selected pot are
stored in memory even if the power is switched off or in case of a power failure, provided the most
recent change to a setpoint temperature was made at least 4 sec. prior to the power outage.
When the unit is again switched on or power is restored, the Vario E returns to the previously
saved operating state.
- 3 -
EN