Troubleshooting - Everbilt SBA025RP Guía De Uso Y Cuidado

Troubleshooting

Problem
The pump does not start or run.
The pump operates but delivers little or no
water.
Possible Cause
1. A fuse is blown.
2. The line voltage is low.
3. The motor is defective.
4. The impeller does not turn.
1. Something is caught in the impeller.
2. The garden hose diameter is too small
or the discharge line is too long.
3. A check valve is installed without a vent
hole.
4. There is air lock in the pump.
5. There are coils or bends in the hose.
7
Corrective Action
1. If blown, replace with a fuse of proper
size.
2. If voltage is under the recommended
minimum, check the size of the wiring
from the main switch on property. If OK,
contact the power company.
3. Replace the pump.
4. If the impeller does not turn, remove the
lower base plate. Locate the source of the
binding.
1. Clean out the impeller.
2. Use a larger diameter garden hose or 1 in.
flexible pipe. Eliminate any excess hose.
Short hoses work best.
3. Drill a 1/16 in. - 1/8 in. (1.6-3.2mm) dia.
hole between the pump discharge and
check valve.
4. Turn off the pump for a few seconds,
clean out the anti-airlock hole and restart
the pump.
5. Straighten the hose.
Please contact 1-844-241-5521 for further assistance.
HOMEDEPOT.COM