Package Contents; Description (Fig. A); Electrical Safety - DeWalt DW568K Manual Del Usuario

E N G L I S H
17 Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Inspect the
E
extension cords periodically and replace them if
damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.

Package contents

The package contains:
1 Heavy duty rotary hammer drill
1 Side handle
1 Depth adjustment rod
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
en - 3

Description (fig. A)

Your D WALT heavy duty rotary hammer drill
E
DW568K(L) has been designed for professional
rotary drilling and hammer drilling as well as light
chipping, chiselling and demolition applications and
for carbide-tipped core drilling.
1 Variable speed switch
2 Tool holder for SDS-plus
3 Mode selector with safety lock
4 Side handle
5 Depth adjustment rod
6 Depth stop clamp
Torque limiting clutch
All rotary hammer drills are equipped with a torque
limiting clutch that reduces the maximum torque
reaction transmitted to the operator in case of
jamming of a drill bit. This feature also prevents the
gearing and electric motor from stalling. The torque
limiting clutch has been factory-set and cannot be
adjusted.
Variable speed
The variable speed feature allows speed to build up
slowly, thus preventing the drill bit from walking off the
intended hole position when starting. The feature also
reduces the immediate torque reaction transmitted to
the gearing and the operator if the hammer is started
with the drill bit in an existing hole.

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
® accessories
15