Ice Dispenser Operation
To avoid property damage, do not dispense ice
directly into thin glass, fine china, or delicate crystal.
• Select cubed or crushed mode by sliding lever on
dispenser panel. Dispense ice by pressing wide
mouthed container against ice dispenser bar.
Important
Reduce spraying of crushed ice by holding wide
mouthed container directly under ice chute and as
high as possible in dispenser area.
• Stop ice dispensing by releasing pressure on bar
before container is full. Some ice will continue to fall.
Do not remove container until last of ice falls.
If dispensing ice continuously, dispenser motor is
designed to shut off after 3 to 5 minutes. Motor resets
after 3 minutes and dispensing can continue.
A slight delay occurs when switching between cubed and
crushed modes. Pieces of crushed ice will vary in size
and shape. "Snow" may form on door and ice chute
when repeatedly dispensing crushed ice. Allow "snow" to
evaporate or wipe dry.
Dispenser operates only with cubes of proper size and
crescent shape. Do not add purchased ice cubes or
other shaped cubes to ice bucket.
Removing Ice Bucket
• Remove ice bucket by lifting bucket and pulling out.
Caution
• Replace ice bucket by sliding in until bucket locks in
place. Ice bucket must be locked in place for proper
ice dispensing. If Deepfreeze
bucket is not in proper location.
A
A. Night light switch
Dispenser Light
(Some models)
A light is activated when dispensing ice or water. Some
models feature a night light.
• Deactivate night light by pushing switch, located
underneath dispenser and left of ice dispenser bar.
Taste and Odor
Observe the following to minimize taste and odor
difficulties:
• Wrap foods in tightly sealed containers or moisture
proof bags.
• Install water filter, R0185011, on water line.
• Contact local water treatment company for
specialized help if difficulties persist.
12
®
door does not close,