Parallel Connection - Master audio PRO SERIE Manual De Usuario

Amate Electroacústica,s.l.
A
Fig.4. PA-208A connection panel
Always use mains power cable supplied by manufacturer.
Never connect the PA-208A to an unearthed mains supply or by using an
unearthed mains cable.
3.CONNECTING

3.1. Parallel connection

Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for further
units. All of the units in this chain must be switched on.
For the mains connection in parallel use the cable with grey Neutrik PowerCon
NAC3FCB at one end and the blue Neutrik PowerCon NAC3FCA at the other end.
Do not connect more than six PA-208A units using the AC Stacking
output connector.
Do not connect PRO series units in parallel using PowerCon- PowerCon
without earth.
PA208A.Ver 1.0
B F E C
H G
D
May 09
20