Tec Hnical Speci F Ication; War Nings A Nd Cl Ea Ni Ng - Orbea DROPPER OC2 Manual Tecnico

4 | OR B EA
TECH N I CAL
SPE CIF I CAT I O N
SEATPOST DIAMETER
31.6mm
31.6mm
31,6mm
31.6mm
31.6mm
31.6mm
27.2mm
· Remote action: gear cable (4mm outer)
· Routing: Internal*
· Minimum insertion: Always observe the minimum insertion indication on the seatpost body
· Compatible saddles: Round rails (7x7 and 7x9)
· Weight: 530 gr (125mm)
* The frame the OC2 Dropper is to be installed on must be compatible with internal routing dropper seatposts. If your
frame does not have a port to this end, the frame is not compatible. Do nor modify the frame to accept the OC2 Drpper
seatpost.
AVAILABLE DROPS SEATPOST TOTAL LENGHT
50mm 288mm
75mm 313mm
100mm 363mm
125mm 413mm
150mm 463mm
170mm 503mm
80mm 404,5mm
TECHN ICA L MAN UAL DROPPER OC2
WAR N IN G S
A ND CL EA NI NG
· After each use, clean your seatpost with a clean soft cloth. Do not use pressure washers or abrasives.
· Before each use, check the collar ring for tighteness. It should be as tight as possible using your bare hands.
· Check periodically the state of the remote cable and outer. If they are not in optimal condition and they present kinks,
cuts or excesive dirt inside, replace them for an optimal operation.
· Do not disassemble the OC2 Dropper. The maintenance and reapair of the seatpost must by carried out by a profes-
sional dealer.
· The seatpost must be in the fully extended position in order to hang or lift the bicycle by the seatpost/saddle. To store
your bicycle or seatpost, do it in the fully extended position.
· Do not lubricate the seatpost stanchion. If it is dirty, clean it following this guide´s indications.
· Overtightening the seatpost clamp beyond the recommended torque settings might cause damage and affect the sea-
tpost operation. Follow the frame/seatpost clamp recommended torque settings.
· Replace the collar ring assembly, the bushings and the guides after every 100 hours of use. This job should be carried
out by a professional dealer.
· Follow all the recommended torque settings.
· Always use soft jaws to clamp the OC2 Dropper on the work stand.
O C | 5
EN