Troubleshooting - AL-KO TSL 2000 W Manual Del Usuario

GB

Troubleshooting

Malfunction
Height adjustment stiff
Motor does not start
Motor has no power
switches off automatically
Burn sites on the surface of the saw cut
Care and maintenance
Before all maintenance and cleaning work, remove the plug from
the mains. Clean the cooling fins and the ventilation holes on the
electric motor on a regular basis.
Check the blade every time before using the saw; only use well
sharpened saw blades.
The saw blade is a wearing part and becomes blunt slowly or
quickly depending on use.
A blunt blade will produce burns at the saw cut and overload the
motor.
Keep the saw blade and the bench plate free of resin.
Regularly clear the inside of the machine and the saw-blade
safety guard from saw dust and off-cuts.
Wearing parts
The saw is naturally subject to more or less wear depending on
use.
For this reason, the saw blade is not included in the guarantee.
Available accessories
Wheels
(Figure H)
Item no. 112 154
For ease of mobility when changing location.
Stable metal construction with continuous axle.
******************************************
Guarantee
During the legal guarantee period, we will remedy any faults due
to faulty materials or manufacture at our discretion by repair or
by the supply of spare parts.
The guarantee period is subject to the current law of the country
in which the machine was purchased.
The guarantee is only valid under the following conditions:
• The machine has been treated properly.
• The operation instructions have been followed.
• Genuine spare parts have been used.
GB 5
Possible cause
Threaded spindle possibly contaminated
Mains fuse has cut out
Power cable to the machine defective
Motor or switch defective
Motor protection switch tripped
Overload due to blunt saw blade
Motor protection switch tripped
Blunt saw blade
Parallel fence out of alignment with
the saw blade
The guarantee is void if:
• Attempts have been made to repair the machine.
• The machine has been altered.
• The machine has been used incorrectly,
(e. g. commercial or communal use etc.).
The following items are excluded from the guarantee:
• Paint damage due to normal wear.
• Wearing parts on the spare parts card which are
marked with the box XXX XXX (X) .
• Internal combustion engines – separate guarantee condi-
tions apply to these from the relevant engine manufacturer.
In the event of a claim under the guarantee, please contact your
dealer or the nearest authorised customer service centre with
this guarantee declaration and a proof of purchase.
The legal guarantee rights of the purchaser in respect of the
seller remain unaffected by the terms of this guarantee.
EEC declaration of conformity
We hereby declare that the machine named below, based on its
design and construction and its form as marketed by us, com-
plies with the relevant fundamental health and safety require-
ments under the EEC directives listed below. This declaration
becomes void in the event of any alterations being made to the
machine without our agreement.
Product: Circular bench saw
Type:
EEC Directives:
98/37/EEC • 89/336/EEC • 73/23/EEC
applied harmonised standards:
EN 55014-1 • EN 55014-1 • EN 60204-1
EN 61000-3-2 • EN 61000-3-3 • EN 1870-1
AL–KO Geräte GmbH D-89359 Kötz
Kötz, 27.08.01
Remedy
Clean the threaded spindle
Check the mains fuse
Call a trained electrician
Contact customer service workshop
Allow motor to cool down
Use a sharp saw blade
Allow motor to cool down
Use a sharp saw blade
Align parallel fence
TSL 2000W
--------------------------------------------------------
A. De Filippo (Development Manger)