Tool Operation; Installing A Ds230 Attachment - Senco DURASPIN DS230 Instrucciones De Operación

Tool Operation

Read sections titled "Safety Warnings" before operating tool.
WARNING
Do not use this product if it is not completely assembled or if any parts
appear to be missing or damaged. Use of a product that is not properly and completely
assembled or with damaged or missing parts could result in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or attachments not
recommended for use with this product. Any such alteration or modification is misuse
and could result in hazardous conditions possibly leading to serious personal injury.
CAUTION
Do not rotate the attachment collar in the locking direction if not fully installed
onto a tool. This could damage the connector components.
If any parts are damaged or missing, please call 1-800-543-4596 for assistance.
INSTALLING A DS230-M1, DS230-S1, DS230-D2 ATTACHMENT
1. Unplug tool from electrical supply or remove battery before installing attachment.
2. Remove the manufacturer's nose cone from the tool.
3. Remove manufacturer's bit and holder if present.
4. Install the appropriate Senco bit (see below), making sure it is fully seated (this may require some force.)
5. Make sure the attachment locking collar is in the unlock position and slide completely onto the tool.
(Note: DS230 models are designed to fit specific screwdrivers. Therefore, they look slightly different
with unique connection features depending on the brand of screwdriver. Refer to the images on the
previous page.
6. Rotate the collar counterclockwise to engage and lock the attachment to the tool.
Unlocked
Locked
INSTALLING THE DS230-D1 ADAPTER AND ATTACHMENT
1. To prepare the screw gun before installing the screw-on adapter.
DeWalt Tool
Output Shaft
Assembly
c. Remove manufacturer's bit and holder if present.
d. Unscrew the stock DeWalt clutch housing by rotating clockwise (threads are left-hand/reversed).
The use of a wrench may be necessary.
e. Remove the output shaft assembly from the stock clutch housing and reinstall into the supplied
Senco adapter and thread onto the DeWalt tool by rotating counterclockwise.
f. Torque adapter onto tool to 50 in. lbs. with an adjustable wrench.
2. Install the bit and the attachment onto the tool as described in steps 4-6 in the previous section.
Bit Type DS230
Phillips EA0300
Square EA0301
Rex EA0302
a. Unplug tool from electrical supply or remove battery before
installing attachment.
b. Remove the nose cone - This can be reinstalled onto the Senco
provided adapter installed in step e. Please note that the internal
tabs in nose cone must be aligned with the adapter slots, and the
Wrench Flats
depth may need to be adjusted to install properly.
9