Tool Operation; Installing A Ds55-M1, Ds55-D2 Attachment; Installing The Ds55-D1 Adapter And Attachment - Senco DURASPIN DS55 Instrucciones De Empleo

Tool Operation

Read sections titled "Safety Warnings" before operating tool.
WARNING
Do not use this product if it is not completely assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result
in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or attachments not recommended for use
with this product. Any such alteration or modification is misuse and could result in hazardous conditions possibly leading
to serious personal injury.
If any parts are damaged or missing, please call +31 320 295 575 for assistance.

INSTALLING A DS55-M1, DS55-D2 ATTACHMENT

1. Unplug tool from electrical supply or remove battery before installing attachment.
2. Remove the manufacturer's nose cone from the tool.
3. Remove manufacturer's bit and holder if present.
4. Install the appropriate Senco bit (see below), making sure it is fully seated (this may require some force.)
5. Make sure the attachment locking collar is in the unlock position and slide completely onto the tool.
(Note: DS55 models are designed to fit specific screwdrivers. Therefore, they look slightly different with unique
connection features depending on the brand of screwdriver. Refer to the images on the previous page.
6. Rotate the collar counterclockwise to engage and lock the attachment to the tool.
Locked
Locked

INSTALLING THE DS55-D1 ADAPTER AND ATTACHMENT

1. To prepare the screw gun before installing the screw-on adapter.
DeWalt Tool
DeWalt Tool
Output Shaft
Output Shaft
Assebly
Assembly
2. Install the bit and the attachment onto the tool as described in steps 4-6 in the previous section.
Unlocked
Bit Type DS230
Unlocked
Phillips
Square
Rex
a. Unplug tool from electrical supply or remove battery before installing
attachment.
b. Remove the nose cone.
c. Remove manufacturer's bit and holder if present.
d. Unscrew the stock DeWalt clutch housing by rotating clockwise (threads
Wrench Flats
Wrench Flats
are left-hand/reversed). The use of a wrench may be necessary.
21mm 20 mm
e. Remove the output shaft assembly from the stock clutch housing and
reinstall into the supplied Senco adapter and thread onto the DeWalt
tool by rotating counterclockwise.
f. Torque adapter onto tool to 50 in. lbs. with a 21 mm wrench.
Bit Type
Philips
EA0300
Square
EA0301
SENCO
EA0302
11
DS55
EA0329B
EA0330B
EA0334B
EN