Troubleshooting - Revell Control Dust Racer Manual De Instrucciones

4 sTarT preparaTIon
The remote control of the vehicle
switches on automatically when the
joystick is actuated. That means that only
the switch on the underside of the
vehicle has to be set to ON (4A). Note:
The vehicle operating time depends on
the quality of the batteries which are
used! The switch on the vehicle must be
set to OFF after use. Otherwise, a drive
command can accidentally be triggered,
causing the vehicle to drive away on its
own, which can lead to considerable
damage.
6 vehICle ConTrol
6A In order to drive forwards, push the throttle lever on the left side of the remote
control forwards.
6B In order to drive backwards, push the throttle lever back.
note: The vehicle stops instantly after the control lever is released.
6C In order to drive along a left curve, push the steering lever on right side of the
remote control towards the left.
6D In order to drive along a right curve, push the steering lever towards the right.
InsTruCTIons For saFe drIvIng
GEnERAL DRiVinG TiPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the speed control immediately in order to prevent
damage to the electronics.
ThE SuiTABLE DRiVinG EnViROnMEnT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
12
5 sTeerIng TrIM adjusTMenT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
if the vehicle pulls to the left or the
right without being steered...
use the trim lever to correct the wheel
alignment by turning it in the opposite
direction. The wheel alignment can be
found on the bottom of the vehicle (cf. 5).

TrouBleshooTIng

Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
• Please replace with new batteries.
Problem: Remote control does not work.
Cause: • The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Check whether the batteries are inserted correctly.
• Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: • The batteries are depleted.
• The connection between the remote control and vehicle has been severed.
Remedy: • Insert new batteries.
• When the model is further than 10 metres away, move towards the model
Additional tips and trick can be found online at www.revell-control.de.
servICe noTes
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13