Sony HVBK-1520 Instrucciones De Instalación página 45

To apply the electromagnetic shielding
1
2
3
4
Remove the eight screws holding the rear panel of the HVR-1500.
Peel off the protective layer from the double-sided tape attached to
the electromagnetic shielding.
Apply the electromagnetic shielding in the positions on the inner
side of the rear panel, as shown in the figure.
Apply the electromagnetic shielding with the double-sided tape
side down.
Electromagnetic shielding
(DDE1)
Replace the rear panel, and fasten the screws.
Electromagnetic shielding
(DDE2)
Installation 45