Suggested Pile Height Settings - Kenmore BC3060 Manual De Uso Y Cuidado

1. Pull cord out of canister to desired
length. The cord will not rewind until the
cord rewind button is pushed.
2. Plug the polarized power cord into a
120 Volt outlet located near the floor.
To rewind: Turn off and unplug the vacuum
cleaner. Hold the plug while rewinding to
prevent damage or injury from the moving
cord. Push cord rewind button.
3. Lower wand from upright position by
pressing on the HANDLE RELEASE pedal.
Handle
Release
4. Select a pile height setting by pressing
the height adjust pedal on the rear of
HOW TO START
the PowerMate
shows on the indicator.
5. Select a position on
the handle three-way
On/Off switch.
Slide the switch forward
to the CARPET position to
turn on suction from the
canister motor and the
PowerMate
CARPET indicator button
will turn green, and the
PowerMate
start to spin.
Slide the switch forward
to the FLOOR position to
turn on canister motor
suction only. The FLOOR indicator button
will turn green, and the PowerMate
brushroll will not spin.
Slide the switch all the way back to turn
the vacuum cleaner off. The CARPET and
FLOOR indicators will both become gray.
SUGGESTED PILE HEIGHT
SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may
require that they be vacuumed with the
PowerMate
carpet damage.
- 11 -
®
. The pile height setting
Height
Adjustment
Pedal
®
brushroll. The
®
brushroll will
®
brushroll turned off to prevent
Height
Adjustment
Indicator
®